Add a file build.info on etc/cloud
with the serial information
Signed-off-by: Samir Akarioh <samir.akarioh@canonical.com>
(cherry picked from commit 105acdebc7)
RISC-V boards tend to boot slowly.
We should provide progress information when booting.
Use 'efi=debug earlycon' on the Linux command line via new file
/etc/default/grub.d/cmdline.cfg.
Signed-off-by: Heinrich Schuchardt <heinrich.schuchardt@canonical.com>
The Nezha and the LicheeRV boards do not have enough memory for an initrd
with most modules. Therefore the number of included modules has to be
reduced.
Create file /etc/initramfs-tools/conf.d/modules_list.conf
to set MODULES=list.
Signed-off-by: Heinrich Schuchardt <heinrich.schuchardt@canonical.com>
Remove redirections of type
command &1>2
Executing the command in the background and creating and empty file '2'
was never intended.
As the messages are information only redirecting to stderr would not make
sense either.
Signed-off-by: Heinrich Schuchardt <heinrich.schuchardt@canonical.com>
The LicheeRV Dock board comes with only 512MB of DRAM so the only difference
with a Nezha image is the fact that we have to remove
cryptsetup-initramfs package which makes the initrd too big for the
board to boot.
Signed-off-by: Alexandre Ghiti <alexandre.ghiti@canonical.com>
3.5G is not enough for riscv64 preinstalled as the creation of the initrd fails
with the following error:
Creating config file /etc/default/grub with new version
Processing triggers for initramfs-tools (0.140ubuntu13) ...
update-initramfs: Generating /boot/initrd.img-5.15.0-1011-generic
zstd: error 25 : Write error : No space left on device (cannot write compressed block)
E: mkinitramfs failure zstd -q -1 -T0 25
update-initramfs: failed for /boot/initrd.img-5.15.0-1011-generic with 1.
dpkg: error processing package initramfs-tools (--configure):
installed initramfs-tools package post-installation script subprocess returned error exit status 1
Signed-off-by: Alexandre Ghiti <alexandre.ghiti@canonical.com>
The image created uses a UEFI bootflow, so we install grub for this board
only. We also need flash-kernel to install the dtb where grub can find
it.
This image is specifically architectured so that it can be installed on
a "factory" board, meaning using the u-boot firmware which was
originally implemented for Fedora, so we need the p3 partition that
embeds a uEnv.txt file to tell u-boot what/where to load next stage.
Signed-off-by: Alexandre Ghiti <alexandre.ghiti@canonical.com>
Łukasz 'sil2100' Zemczak
Utkarsh Gupta
Samir Akarioh
Steve Langasek
Heinrich Schuchardt
Alexandre Ghiti
William Wilson
Simon Quigley